MASTER/SLAVE COMMUNICATION PROTOCOLS FOR SCADA SYSTEMS
DOI:
https://doi.org/10.24867/08BE33BubnjevicKeywords:
Protocol, SCADA, VanComm ProtokolAbstract
The document presents a software solution which is used for simulaton of slave part of VanComm Master/Slave communication protocol. The implemented software solution may be used for simulation of communication between master and slave sides, where master side sends requests for reading of data or command execution, and slave part process and executes requests which came from master side while using VanComm communication protocol.
References
[1] Perl simulator. https://www.perl.org/ (Accessed 23.09.2019.)
[2] What is SCADA? https://inductiveautomation.com/resources/article/what-is-scada. (Accessed 24.09.2019.)
[3] DNP3 SPECIFICATION, Version 2.01, DNP Users Group, 2007.
[4] P. Matoušek, Description and analysis of IEC 104 Protocol, Brno University of Technology, 2017.
[5] Appendix B, Ferranti International Controls, Message Standard: Van-Comm, Ferranti International Controls, 1986.
[2] What is SCADA? https://inductiveautomation.com/resources/article/what-is-scada. (Accessed 24.09.2019.)
[3] DNP3 SPECIFICATION, Version 2.01, DNP Users Group, 2007.
[4] P. Matoušek, Description and analysis of IEC 104 Protocol, Brno University of Technology, 2017.
[5] Appendix B, Ferranti International Controls, Message Standard: Van-Comm, Ferranti International Controls, 1986.
Downloads
Published
2020-05-29
Issue
Section
Electrotechnical and Computer Engineering
