APPLICATION OF REVERSE ENGINEERING IN THE REDESIGN OF THE METAL BAND SAW STAND
DOI:
https://doi.org/10.24867/26AM11TomicKeywords:
Redesign, 3D Scanning, Reverse Engineering, Metal band saw standAbstract
As part of this master's work, the band saw stand was redesigned. A 3D scan was performed using a 3D scanner "EinScan Pro 2X" based on structured light. After the 3D scanning, the stand was modeled with the aim of obtaining its CAD model. A CAD inspection tool was also applied to verify the modeled CAD model. After this, the tool stand was redesigned. Structured analysis was also carried out with the aim of verifying the load capacity of the redesigned and reinforced tool stand, as well as its practical application.
References
[1] Prof. dr Miroslav Plančak, “Brza izrada prototipova, modela i alata”, Fakultet tehničkih nauka, Novi Sad 2009.
[2] Šokac M., Budak I., Katić M., Jakovljević Ž., Santoši Ž., Vukelić Đ., “Improved surface extraction of multi- material components for single-source industrial X-ray computed tomography”, Measurement, Vol. 153, 2020.
[3] Šokac M., Santoši Ž., Budak I., Car Z., Vukelić Đ., “Combination of contact and optical 3D digitizing methods for their application in reverse engineering”, 8. International Conference on Innovative Technologies IN-TECH, Ljubljana: Faculty of Mechanical Engineering, 11-13 September, 2017, pp. 65-68, ISBN 0184-9069.
[4]https://www.shining3d.com/blog/handheld-3d-scanner-light-sources-laser-lines-vs-structured-light-vs-infrared/ (pristupljeno 20.09.2023).
[5] Budak I.; Hodolič J., „Reverzibilno inženjerstvo i CAD- inspekcija-skripta“, Fakultet tehničkih nauka, Novi Sad, 2007.
[6]http://www.dpm.ftn.uns.ac.rs/attachments/article/64/ Modelovanje_Predavanje_5_Numerika_Uvod+MKE_1.pdf (pristupljeno 20.09.2023).
[2] Šokac M., Budak I., Katić M., Jakovljević Ž., Santoši Ž., Vukelić Đ., “Improved surface extraction of multi- material components for single-source industrial X-ray computed tomography”, Measurement, Vol. 153, 2020.
[3] Šokac M., Santoši Ž., Budak I., Car Z., Vukelić Đ., “Combination of contact and optical 3D digitizing methods for their application in reverse engineering”, 8. International Conference on Innovative Technologies IN-TECH, Ljubljana: Faculty of Mechanical Engineering, 11-13 September, 2017, pp. 65-68, ISBN 0184-9069.
[4]https://www.shining3d.com/blog/handheld-3d-scanner-light-sources-laser-lines-vs-structured-light-vs-infrared/ (pristupljeno 20.09.2023).
[5] Budak I.; Hodolič J., „Reverzibilno inženjerstvo i CAD- inspekcija-skripta“, Fakultet tehničkih nauka, Novi Sad, 2007.
[6]http://www.dpm.ftn.uns.ac.rs/attachments/article/64/ Modelovanje_Predavanje_5_Numerika_Uvod+MKE_1.pdf (pristupljeno 20.09.2023).
Downloads
Published
2024-01-31
Issue
Section
Mechanical Engineering
