HARDNESS – STRAIN RELATION IN A BULK FORMING WITH A CYLINDICAL TOOL
DOI:
https://doi.org/10.24867/28AM04VukovicKeywords:
Cold forming, Hardness, StrainAbstract
The main characteristic of cold formed metal parts is strain hardening which results in an increase of hardness and strenght of material. In the paper hardness distribution within a part formed by a cylindrical tool is presented.
References
[1] L. Šiđanin, “Mašinski materijali SV 2”, FTN Novi Sad, 2014.
[2] W. D. Callister, D. G. Rethwisch, “Materials science and engineering, An introduction”, Wiley USA, 2014.
[3] E. Broitman, “Indentation Hardness Measurements at Macro-, Micro-, and Nanoscale: A Critical Overview”, Tribology Letters, Vol. 65, No. 1, 2017.
[4] G. Sundararajan, Y. Tirupataiah, “The hardness-flow stress correlation in metallic materials”, Bulletin of Materials Science, Vol. 17, No. 6, pp. 747–770.
[5] D. Tabor, “The hardness of metals”, Oxford at the Clarendon press, 1951.
[2] W. D. Callister, D. G. Rethwisch, “Materials science and engineering, An introduction”, Wiley USA, 2014.
[3] E. Broitman, “Indentation Hardness Measurements at Macro-, Micro-, and Nanoscale: A Critical Overview”, Tribology Letters, Vol. 65, No. 1, 2017.
[4] G. Sundararajan, Y. Tirupataiah, “The hardness-flow stress correlation in metallic materials”, Bulletin of Materials Science, Vol. 17, No. 6, pp. 747–770.
[5] D. Tabor, “The hardness of metals”, Oxford at the Clarendon press, 1951.
Downloads
Published
2024-09-02
Issue
Section
Mechanical Engineering
