Proceeding of the Faculty of technical Sciences, Novi Sad

Mechanical Engineering

Vol. 35 No. 03 (2020): Proceedings of the Faculty of Technical Sciences

MILLING MACHINING SUPPORTED BY ULTRASONIC

DOI:
https://doi.org/10.24867/07AM12Stanic
Submitted
October 25, 2019
Published
2020-02-18

Abstract

The combination of conventional milling and ultrasonic machining, more precisely ultrasonic vibrations, resulted in a hybrid machining technology called ultrasonic assisted milling. In addition to the description of each technology, this paper is accompanied by a series of experiments comparing the output characteristics obtained by conventional milling and ultrasonic assisted milling.

References

[1] D. Milikić, M. Gostimirović, M. Sekulić: Osnove tehnologije obrade rezanjem, Fakultet tehničkih nauka, Novi Sad, 2008.
[2] M. Gostimirović: Nekonvencionalni postupi obrade, Fakultet tehničkih nauka, Novi Sad, 2009.
[3] A. Latif: Experimental study of biomedical stainless steel 316L vibration assisted milling using retrofittable 1D UVAM worktable, Faculty of Mechanical and Manufacturing Engineering, Johor, 2017.
[4] J. Liu, X. Jiang, X. Han, Z. Gao, D. Zhang: Effects of rotary ultrasonic elliptical machining for side milling on the surface integrity of Ti-6Al-4V, School of Mechanical Engineering and Automation, Beijing, 2018.
[5] S. Lin, C. Kuan, C. She, W. Wang: Application of Ultrasonic Assisted Machining Technique for Glass-Ceramic Milling, World Academy of Science, Engineering and Technology International Journal of Mechanical and Mechatronics Engineering Vol:9, No:5, 2015.
[6] M. Hafiz, M. Kawaz, W. Mohamad, M. Kasim, R. Izamshah, J. Saedon, S. Mohamed: A review on feasibility study of ultrasonic assisted machining on aircraft component manufacturing, Faculty of Manufacturing Engineering, Malaysia, 2017.
[7] M. M. Abootorabi Zarchi, M. R. Razfar, A. Abdullah: Influence of ultrasonic vibrations on side milling of AISI 420 stainless steel, Faculty of Mechanical Engineering, Teheran, 2012.
[8] J. Zhang, H. Li, J. Wang, X. Wang, X. Shen: Ultrasonic vibration-assisted milling of aluminum alloy, Department of Mechanical Engineering, Jinan, 2012.
[9] J. Xiaoliang, X. Bouyan: Experimental study on surface generation in vibration-assisted micro-milling of glass, Oklahoma State University, Stillwater, 2015.