Proceeding of the Faculty of technical Sciences, Novi Sad

Industrial Engineering and Management

Vol. 34 No. 05 (2019): Proceedings of the Faculty of Technical Sciences

DESIGN OF SUPPORTING STRUCTURE FOR STRUCTURED LIGHT SCANNER

  • Nemanja` Popović
  • Igor Budak
DOI:
https://doi.org/10.24867/02GI19Popovic
Submitted
April 18, 2019
Published
2019-04-18

Abstract

This paper presents a new design of a supporting structure for a 3D digitizing method based on structured light. In order to perform the verification and numerical analysis of the load capacity of the structure design, the Finite Element Method (FEM) was applied. The results obtained using FEM analysis indicate that the current design of the supporting structure allows good load capacity.

References

[1] Prof. dr Miroslav Plančak, "Brza izrada prototipova, modela i alata", Novi Sad, Fakultet tehničkih nauka, 2009.
[2] I. Budak, J.Hodolič, I. Bešić, Đ.Vukelić, P. Herbert Osanna, H. M. Durakbasa, "Koordinatne merne mašine i CAD inspekcija", Tempus projekat broj IB_41120-2006, Fakultet tehničkih nauka, Novi Sad, 2006.
[3] Historijski razvoj, principi i primjena metoda konačnih elemenata, http://am.unze.ba/mkpr/MKE%201.pdf (pristupljeno u Oktobru 2018.)
[4] Dhatt, Gilbert Touzot, Emmanuel Lefrancois: "Finite element method", WILEY, 2012.