MODELING AND CONTROL OF THREE-PHASE BOOST RECTIFIER
DOI:
https://doi.org/10.24867/09BE14ZecarKeywords:
Three-phase Boost rectifier, sinusoidal pulse width modulation, Typhoon HIL emulationAbstract
In this paper modeling and control of a Three Phase Boost rectifier is presented. Sinusoidal pulse width modulation is used. The control consists of a current-voltage loop. The dq model of the rectifier is shown and transfer functions and parameters of PI regulators are calculated. Model is created and emulated in Typhoon HIL software.
References
[1] Y. Chang et al., “Small-signal modeling of three-phase boost rectifier under non-sinusoidal condition”, APEC 2008, pp.1195-1199.
[2] https://www.mathworks.com/matlabcentral/fileexchange/62334-three-phase-spwm-boost-rectifier-with-closed-loop-control
[3] https://www.typhoon-hil.com/
[4] https://www.typhoon-hil.com/products/hil-software/
[5] http://www.cei.upm.es/media/TFM/Borovic_Uros_TFM_2014.pdf
[6] K.N. Areerak et al., “DQ-transformation approach for modelling and stability analysis of AC-DC power system with controlled PWM rectifier and constant power loads”, PEMC, Poznan, 2008.
[2] https://www.mathworks.com/matlabcentral/fileexchange/62334-three-phase-spwm-boost-rectifier-with-closed-loop-control
[3] https://www.typhoon-hil.com/
[4] https://www.typhoon-hil.com/products/hil-software/
[5] http://www.cei.upm.es/media/TFM/Borovic_Uros_TFM_2014.pdf
[6] K.N. Areerak et al., “DQ-transformation approach for modelling and stability analysis of AC-DC power system with controlled PWM rectifier and constant power loads”, PEMC, Poznan, 2008.
Downloads
Published
2020-08-27
Issue
Section
Electrotechnical and Computer Engineering
