Proceeding of the Faculty of technical Sciences, Novi Sad

Mechanical Engineering

Vol. 36 No. 06 (2021): Proceedings of the Faculty of Technical Sciences

PRODUCT AND MOLD DESIGN FOR INJECTION MOLDING OF DECORATIVE MASK FOR ELECTRICAL INSTALLATION PROGRAM

  • Tamara Iličić
  • Mladomir Milutinović
DOI:
https://doi.org/10.24867/13AM01Ilicic
Submitted
June 3, 2021
Published
2021-06-03

Abstract

In this paper the process of modeling a decorative mask for the electrical installation components is given as well as a mold design for mold injection of this part. A numerical simulation of the injection molding process was carried out in order to validate the part and mold design, and to check the process parameters. In continuous, based on the relevant factors, an injection machine was selected.

References

[1] Vilotić D: ''Tehnologija injekcionog presovanja polimera'', Fakultet tehničkih nauka, Departman za proizvodno mašinstvo, Novi Sad, (2007).
[2] Vilotić D.: „Mašine za injekciono presovanje,“ Falultet tehničkih nauka, Novi Sad, 2013.
[3] Perošević B.: „Kalupi za injekciono presovanje plastomera,“ Naučna knjiga, Beograd, 1995.
[4] www.arburg.com