Proceeding of the Faculty of technical Sciences, Novi Sad

Mechanical Engineering

Vol. 38 No. 06 (2023): Proceedings of Faculty of Technical Sciences

THE EFFECT OF HOLDING PRESSURE ON THE DIMENSIONAL STABILITY OF THE INJECTED PART

DOI:
https://doi.org/10.24867/23AM01Cvjetkovic
Submitted
June 7, 2023
Published
2023-06-07

Abstract

The aim of this work is experimental examina­tion of the influence of holding pressure on the dimen­zional stability of the finished part. The paper also inclu­des the theoretical foundations of the injection molding process and the influence of basic parameters on the injection molding process.

References

[1] D.M. Bryce, “Plastic Injection Molding”, Michigan, SME, 1996.
[2] I. Čatić, “Proizvodnja polimernih tvorevina”, Zagreb, Društvo za plastiku i gumu, 2006.
[3] J. White, “Twin Screw Extrusion”, Munich, Hanser Gardner Publications, 1991.
[4] B. Nedić, “Tehnologije prerade plastičnih masa”, Kragujevac, Mašinski fakultet Kragujevac, 2008.
[5] B. Nedić, V. Đukić, “Plastične mase”, Kragujevac, Mašinski fakultet Kragujevac, 2004.
[6] E. Rudnik, “Compostable Polymer Materials”,Warsaw, Elsevier Science, 2007.
[7] H. F. Mark, “Encyclopedia of polymer science and technology”, Hoboken, Wiley-Interscience, 2004.
[8] D. Vilotić, “Mašine za injekciono presovanje – skripta”, Novi Sad, Fakultet tehničkih nauka, 2008.
[9] S. Kulkarni, “Robust Process Development and Scientific Molding”, Munich, Hanser Publications, 2017.
[10] https://www.moldchina.com/post/holding-pressure/ (pristupljeno u januaru 2023).
[11] B. Pilić, “Polimeri i polimerni materijali”, Novi Sad, Tehnološki fakultet, 2022.