OPTIMIZATION OF CABLE PRODUCTION THROUGH THE APPLICATION OF LEAN TOOLS AND QUALITY TOOLS IN THE AUTOMOBILE INDUSTRY
DOI:
https://doi.org/10.24867/30GI06VolarevicKeywords:
Ferrite Ring, Brainwriting, Ishikawa Diagram, FMEA Analysis, 5 Why Method, Poka-Yoke, DMAIC Cycle, Quality ControlAbstract
The paper analyzes the problem of the ferrite ring not moving over the cable, identifies causes, and proposes solutions to minimize this issue in the production process. Brainwriting, Ishikawa diagram, FMEA, 5 Whys, Poka-Yoke, and DMAIC cycle were used. Suggested improvements include documentation control and staff training, leading to reduced errors and increased production efficiency.
References
[1] Vulanović V., Stanivuković D., Metode i tehnike unapređenja procesa rada, FTN, 2012.
[2] Delić M., Prezentacije sa predmeta Metode i tehnike unapređenja kvaliteta
[4] https://tulip.co/glossary/five-whys/
[5] https://bs.atomiyme.com/feritni-prsten-sta-je-to-kako-napraviti-feritni-prsten-s-vlastitim-rukama/
[6] Vulanović S., Prezentacije sa predmeta Lean 6 sigma
[7] Shingo S., Zero Quality Control, Productivity Press, 1986
[8] Paul C. R., Introduction to Electromagnetic Compatibility, Wiley, 2006
[9] Rikalović A., Prezentacije sa predmeta Proizvodne strategije
