MODELING OF CUTTING FORCES IN FACE MILLING OF HIGH-CHROME CAST IRON
DOI:
https://doi.org/10.24867/06AM03ZdrnjaKeywords:
Face milling, high-chromium cast iron, cutting forces, data acquisitionAbstract
Within this paper experimental results are obtained in machining with the main milling of high - chromium iron. The results were presented as diagrams and tables and their analysis was performed. Measurement and presentation of these results was carried out through a measurable acquisition system. The paper describes this system and how it works.
References
[1] P. Kovač, D. Milikić, “Rezanje Metala”, Novi Sad, Februar, 1998.
[2] Milikić, D., Gostimirović, M., Sekulić, M.:Osnove tehnologije obrade rezanjem, Fakultet tehničkih nauka, Novi Sad, 2008.
[3] M. Sekulić,“Razvoj podloga za proračun sila rezanja”, Magistarski Rad, FTN, Novi Sad, Oktobar, 1998.
[4] Savković, B. : Modeliranje funkcija obradivosti pri procesu obrade glodanjem, Doktorska disertacija, Univerzitet u Novom Sadu, Fakultet Tehničkih Nauka, Novi Sad 2015.
[5] Mijić, A.: Modeliranje sila rezanja pri čeonom glodanju, Fakultet tehničkih nauka, Novi Sad, 2009.
[2] Milikić, D., Gostimirović, M., Sekulić, M.:Osnove tehnologije obrade rezanjem, Fakultet tehničkih nauka, Novi Sad, 2008.
[3] M. Sekulić,“Razvoj podloga za proračun sila rezanja”, Magistarski Rad, FTN, Novi Sad, Oktobar, 1998.
[4] Savković, B. : Modeliranje funkcija obradivosti pri procesu obrade glodanjem, Doktorska disertacija, Univerzitet u Novom Sadu, Fakultet Tehničkih Nauka, Novi Sad 2015.
[5] Mijić, A.: Modeliranje sila rezanja pri čeonom glodanju, Fakultet tehničkih nauka, Novi Sad, 2009.
Downloads
Published
2019-12-16
Issue
Section
Mechanical Engineering
