Proceeding of the Faculty of technical Sciences, Novi Sad

Mechanical Engineering

Vol. 34 No. 11 (2019): Proceedings of the Faculty of Technical Sciences

DEVELOPMENT AND DESIGN OF MOLD FOR INJECTION MOLING OF FITTINGS ∅110/15° ∅110/30°

  • Zvonko Magoč
  • Mladomir Milutinović
DOI:
https://doi.org/10.24867/05AM03Magoc
Submitted
October 29, 2019
Published
2019-10-29

Abstract

In this paper a design solution for mold for injection molding of  and  fittings is given. Those fittings are standard elements of a sewer system. In addition, the mold design and the molding process parameters were analyzed using software package.

References

[1] Milorad Jovanović, Vukić Lazić, Dragan Adamović, Neda Ratković: Mašinski materijali, Mašinski Fakultet, Kragujevac, 2003.
[2] Bogdan Nedić, Vladislav Đukić: Plastične mase, Mašinski Fakultet, Kragujevac, 2004.
[3] Bogdan Nedić, Nataša Vesić, Darko Vasiljević: Boja, kolometrija i plastične mase, Mašinski Fakultet, Kragujevac, 2018.
[4] Boško Perošević: Kalupi za injekciono presovanje plastomera (termoplasta), naučna knjiga, Beograd, 1995.
[5] www.Pestan.net/wp-content/uploads/2018/08/2018-PIPING_SOLUTIONS-SRB-web.pdf (13.05.2019.)