UTICAJ PARAMETARA OBRADE NA HRAPAVOST OBRAĐENE POVRŠINE PRI STRUGANJU ČELIKA 42 CrMo4

Ranko Kovačević

doi:10.24867/31AM09Kovacevic

Mechanical Engineering

Vol. 40 No. 06 (2025): Proceedings of the Faculty of Technical Sciences

THE INFLUENCE OF MACHINING PARAMETERS ON THE SURFACE ROUGHNESS DURING TURNING OF STEEL 42CrMo4

Ranko Kovačević

31AM09Kovacevic.pdf (Serbian)

DOI:: https://doi.org/10.24867/31AM09Kovacevic
Submitted: June 10, 2025
Published: 2025-12-10

Abstract

This paper investigates the influence of cutting parameters on the surface roughness during turning of steel 42CrMo4. By applying the Taguchi method in the MINITAB software, an analysis of the experimentally obtained results was carried out. The results show that the Taguchi method and ANOVA analysis lead to the same results, and it was found that the greatest influence on surface roughness is feed rate.

References

[1] Klarić, S. (2009). Upravljanje kvalitetom – alati i metode poboljšanja, Mašinski fakultet, Mostar.
[2] Sekulić, M. (2010). Primena Tagučijevog metoda u planiranju eksperimenta, skripta, Univerzitet u Novom Sadu, Fakultet tehničkih nauka, Departman za proizvodno mašinstvo, Novi Sad.
[3] Pejić, V. (2016). Modelovanje i optimizacija procesa glodanja vretenastim glodalima, Doktorska disertacija, Univerzitet u Novom Sadu.

[1] [1] Klarić, S. (2009). Upravljanje kvalitetom – alati i metode poboljšanja, Mašinski fakultet, Mostar.

[2] [2] Sekulić, M. (2010). Primena Tagučijevog metoda u planiranju eksperimenta, skripta, Univerzitet u Novom Sadu, Fakultet tehničkih nauka, Departman za proizvodno mašinstvo, Novi Sad.

[3] [3] Pejić, V. (2016). Modelovanje i optimizacija procesa glodanja vretenastim glodalima, Doktorska disertacija, Univerzitet u Novom Sadu.